Installation

6 main installation steps

The driver optimisation module can be installed in just a few simple steps, and is accessible to anyone. Here is the illustrated procedure for all vehicles.

First stage of installation: disconnect the accelerator plug

STEP 1

Switch off the ignition, wait 10 minutes and remove the accelerator plug.

Connect the plugs supplied with the DRIVAO

STEP 2

Connect the DRIVAO plugs (original manufacturer) to those which have just been released.

Connecting the plug to the DRIVAO box

STEP 3

Connect the plug at the other end of the wiring to the DRIVAO module.

Switch the ignition on without starting the engine

STEP 4

In neutral, with the handbrake on (or in position P), switch on the ignition without starting the engine.

Depress the gas pedal fully for 2 seconds

STEP 5

Depress the accelerator fully and hold for 2 seconds. Repeat this two or three times...

The Drivao is now calibrated. Take a test drive

STEP 6

The Drivao has just self-calibrated. Start the engine and carry out a test drive.

The full installation in video

Can a DRIVAO be fitted to your vehicle?

The answer is just a few clicks away…
SEE CATALOGUE